Two Thirds Keyboard Impressed by Outdated Letterpress Sort Case


    A century in the past, earlier than computer systems and automatic printing processes, books and different paperwork had been created utilizing letterpress printing. Also called reduction printing, the method makes use of movable sort composed of particular person letters, symbols and punctuation marks, that are set right into a chase after which inked with a curler. The press then applies stress to the kind or picture, transferring the ink to the paper and creating the specified impression.

    Sort circumstances had been used to place the printing blocks, and typesetters would make the most of majuscule letters from the higher case of sort, and minuscule letters from the decrease case of sort when setting a web page. Letters and symbols that had been routinely used, reminiscent of E and S, would garner a bigger compartment inside the case, whereas seldom used letters and symbols had been delegated to smaller compartments. Matthew Dockery got here up with a novel customized mechanical keyboard based mostly on these sort circumstances.

    Dockery’s Two Thirds Keyboard was constructed round a Teensy 2.0 and incorporates a break up design, with the left and proper sides separated by a niche. The keyboard can also be designed with a low profile, permitting simpler entry to the keys and helps to cut back pressure and fatigue on the wrists.

    Dockery designed a customized PCB for his challenge, full with silkscreened paintings to suit the letterpress format, which is outfitted with a mounting plate to carry the switches in place. It was at this level Dockery encountered an issue when it comes to keycaps. Producers produce caps measured in “items,” that are roughly 19mm in width for normal letters. For instance, the letter Q is one unit, whereas a typical spacebar is 6.25 items. That stated, there’s nothing typical about Dockery’s design.

    He additionally skilled a problem with stabilizer sizes, which correspond with the longer or wider keycaps, enabling them to take care of a degree typing angle. To beat these points, Dockery turned to 3D printing and produced his personal caps utilizing an Anycubic Photon, which turned out fairly properly. He even applied Kaihl blue switches and a laser-cut wood case based mostly on the California-style letterpress format to finish his construct. The result’s an attention-grabbing keyboard any fanatic could be proud to have of their assortment, albeit with a protracted studying curve for typing.


    Please enter your comment!
    Please enter your name here